TF: 1.844.ESC(372).8877

Cleanroom Mechanical Systems
Cleanroom Mechanical Systems

Mechanical Systems

Mechanical Systems in a Cleanroom, can range from simple to very complex. Typical Systems Are Found below.

We can help you understand the various systems available, and choose the best solution for your project.

Hot Water & Steam

Hot Water / Glycol Systems

Hot water systems can range from a small electric hot water heater for single sink or washroom, to large natural gas systems for whole facility systems.

If used for preheating of outside air, where there is a possibility of freezing, we recommend glycol, or coils with freeze protection capabilities.

Steam Systems

Steam systems offer larger capacities with smaller piping, and can be used for humidification.

Clean Steam Systems

Clean Steam systems can be used for pharmaceutical applications, to humidify and clean and sanitize process equipment and piping.

Cleanroom Process Piping
Cleanroom Process Piping
Clean Dry Air Compressor
Clean Dry Air Compressor

Compressed Air

Compressed Air systems are one of the most common utilities in Cleanrooms.

Air compressors and associated refrigerated or Desiccant Dryer systems to provide “dry” Air.

Compressor Styles vary with Capacity, Volume Required, and Storage Capacity.

PIPING SYSTEMS

Piping systems for compressed air can be from many available materials:

Black Iron Pipe
Galvanized Pipe
Copper Pipe
Stainless Steel
KiTec

Compressed Gases

Cleanrooms use a variety of Process Compressed gases.

The requirements will be defined by an analysis of the individual process equipment matrix.

We can help you understand the various systems available, and choose the best solution for your project.

Cleanroom Compressed Gases
Cleanroom Compressed Gases
Cleanroom Vacuum Inlet
Cleanroom Vacuum Inlet

Vacuum Systems

Vacuum systems can be used for process and for cleaning systems.

Process Vacuum Systems

Process systems are a designed the quantity and vacuum pressure. The layout and sizing is designed from the equipment Matrix.

Vacuum Cleaning Systems

We recommend a central vacuum system for the cleaning of the Cleanroom where possible.

Portable HEPA Vacuum systems are available, however the particle sizes being measured is a Cleanroom are smaller than can be observed by the human eye. If the HEPA Filter is not installed correctly, you may be contaminating the space, unknowingly.

We recommend that a tool kit be available for every Cleanzone to reduce cross contamination.

We can help you understand the various systems available, and choose the best solution for your project.

Cooling Towers

On large process systems, where water cooled by ambient conditions can be used, a cooling tower is a very economical method of providing this cooling.

They are also used on large tonnage chiller systems, to provide the condensing medium.

We can help you understand the various systems available, and choose the best solution for your project.


Cooling Towers
Cooling Towers

Copyright © 2015 ESC. All rights reserved.